Press "Enter" to skip to content

Month: December 2017

Compendium shade

Since these shades are available second-hand pretty cheap, this is a silly thing to make unless you have an oddball front standard. I’d made one years ago for my old 5×7, but it was a little bulky to use for my new camera. After spending the morning trying in vain to find the outside dimensions of the Toyo-View compendium hood I just made one out of materials I had on hand.  Why do retailers list the size of the bloody box it comes in, and not the sizeof the unit itself? I went through the same thing trying to find a low profile cold shoe.

5×7 Part 4, errata

Camera turned out well, but though I would compile a list of the things I wish I could do over- and probably will have to do over at some point. Will update the list as new ones are discovered.

Shafts

 I cut the shaft flush with the bed, and tapped and Locktite’d 6-32 studs into each end for the focus and lock knobs. Would have been better to leave the shafts long on the focus side and pin the knobs to the shaft, as done with the gears themselves. The studs are fine for locking knobs, but probably too weak to handle the torque from the focusing knobs over time.